Genie battery charger manual

2.) Connect the negative (black) battery clamp or eyelet terminal connector to the negative (NEG,N,-) battery terminal or vehicle chassis. 3.) Connect the battery charger’s AC power plug into a suitable electrical outlet. Do not face the battery when making this connection. 4.) When disconnecting the battery charger, disconnect. battery owner’s manual prior to using this product. The GB40 is for jump starting volt lead-acid batteries only. Connecting to the Battery. Before connecting to the battery, verify that you have a volt lead-acid battery. The GB40 is not suitable for any other type of battery. Identify the correct polarity of the battery terminals on the. Force mode allow the charger to manually begin charging when the connected battery’s voltage is too low to be detected. If battery voltage is too low for the charger mode button.

Part No Genie AWP 5 Sixth Edition Operator’s Manual Battery and Charger Safety - DC Models Burn Hazards Batteries contain acid. Always wear protective clothing and eyewear when working with batteries. Avoid spilling or contacting battery acid. Neutralize battery acid spills with baking soda and water. Battery pack must remain in upright position. GENIE MANUAL VER GENIE MANUAL VER There could be a spark during charging. Be careful when using fuels, solvents or other flammables near the charger or batteries. An explosion could result causing death or serious injury. This charger s intended only for use on GENIEs equipment and batteries. (WITH BUILT IN ON-BOARD CHARGER) Perform a battery charging cycle before using the machine. To recharge the battery: 1. Make sure the recovery and solution tanks are empty. 2. Move the machine to a volt electrical outlet. 3. Remove the rubber battery charger socket protection on the back of the machine. 4. Plug the power cable (provided with machine) into the battery charger. 5.

Genie Scissor Lift Battery Chargers for industrial lifts, aerial work platforms, Genie Runabout, articulating Z-booms. Direct replacement chargers. If you have any questions, call Genie Industries. safety and operator's manuals and machine Do not use any battery charger greater than 24V to. Genie GR, GR, GR Battery and Charger Instructions, To Charge Batteries. Battery and Charger Instructions, To Charge Batteries.